Phone-800-215-1438 Email for info- [email protected]

Mass Flow Meter
Mass Flow Meter
Mass Flow Meter
Mass Flow Meter

Apex Mass Flow Meter for Low Pressure Drop

$1,530.00 – $5,650.00

Apex Low Pressure Drop Mass Flow Meters for pressure and vacuum applications. These highly accurate mass flow controllers for inert and other non-corrosive applications can be customized with a number of options. Other options can purchased by calling us at 800-215-1438.

 

Flow Rate-  Full scale flow rate of the mass flow meter. turndown ration is 200:1

Calibration Gas – Gas used for factory calibration. There are 30 on-board gases on each mass flow controller that can be chosen as the gas measured. The unit is in calibration for any of the gases in the library.

Output – Output of the mass flow controller is in the form of 0-5V, 0-10V or 4-20 mAmps. Every Apex device has RS-232 capability and does not need to be specified.

Totalizer- Gas Flow Totalizer can be specified as a yes/no option

 

**For more customizable options,  call us at 800-215-1438 or visit our Apex Systems Configuration Builder 

SKU: N/A Categories:

Description

*For more customizable options, visit our Apex Systems Configuration Builder**

 

The Apex Low Pressure Drop Mass Flow Meter allows control of gas flow even where the pressure differential is low or can not be disturbed. This option can reach full-scale pressure drops as low as 0.06 PSID. When you have an application where keeping the pressure differential steady is essential or there is minimal pressure to work with, the Apex Low Pressure Drop Mass Flow Meter is the choice for you.

A 115V/60Hz power cable(PVPS24U) is available to power the unit.

For the end user, flows can be read and the controller set via the on-board display. FlowVision Software can be purchased for using a computer to record and graph the flows. The gas selection can also be made from the computer.

For use with a system, a 6 ft. cable(DC-61) or a 25 ft. cable(DC-251) can be purchased in the communication cable section. One end is the 9 pin Din connector to connect to the Apex MFM, while the other end are blank wires.

Additional information

Flow Rate

0.5 sccm Full Scale, 1.0 sccm Full Scale, 2 sccm Full Scale, 5 sccm Full Scale, 10 sccm Full Scale, 20 sccm Full Scale, 50 sccm Full Scale, 100 sccm Full Scale, 200 sccm Full Scale, 500 sccm Full Scale, 1 slpm Full Scale, 2 slpm Full Scale, 5 slpm Full Scale, 10 slpm Full Scale, 20 slpm Full Scale, 50 slpm Full Scale, 100 slpm Full Scale, 500 slpm Full Scale, 1000 slpm Full Scale
Calibration Gas

Air, Nitrogen, Oxygen, Acetylene (C2H2), Air, Argon (Ar), i-Butane (i-C4H10), • n-Butane (n-C4H10), Carbon dioxide (CO2), Carbon monoxide (CO), Deuterium (D2), Ethane (C2H6), Ethylene/Ethene (C2H4), Helium (He), Hydrogen (H2), Krypton (Kr), Methane (CH4), Neon (Ne), Nitrous Oxide (N2O), Propane (C3H8), Sulfur Hexafluoride (SF6), Xenon (Xe)
Output Signal

0-5V, 0-10V, 4-20mAmp
Totalizer

No, Yes

You may also like…

Related products

Apex Vacuum LLC, Some rights reserved.

Terms of Use - Privacy Policy