Apex Vacuum Pressure Controller-Vacuum & Pressure Applications



Pressure Control Valve: Standard Valve

Setpoint Input-Output Communications:  0-5V, 0-10V or 4-20 milliAmps

Output: 0-5V, 0-10V or 4-20 milliAmps

Connectors for Cable: 8-pin Din



Vacuum Pressure Controller for vacuum and pressure applications.  Cannot be used for vacuum lower than about 8 torr. Accurate to +/-0.5% of FS and repeatable to +/-0.5% of full scale.

A 115V/60Hz power cable(PVPS24U) is available to power the unit.

The Apex Mass Pressure Controller can be set via the on-board display. Input and Output are a standard 0-5V. . For the end user, flows can be read and the controller set via the on-board display. FlowVision Software can be purchased for using a computer to record and graph the flows. The gas selection can also be made from the computer.

For use with a system, a 6 ft. cable(DC-61) or a 25 ft. cable(DC-251) can be purchased in the communication cable section. One end is the 9 pin Din connector to connect to the Apex MFC, while the other end are blank wires.

Additional information

Pressure Controller Range

P-15psia, P-30psia, P-100psia, P-500psia, P-1000psia, P-1500psia, P-2000psia, P-3000psia, P-2inH20, P-1psig, P-5psig, P-15psig, P-30psig, P-100psig, P-500psig, P-1000psig, P-2000psig, P-3000psig

Input/Output Signal

0-5V, 0-10V, 4-20mAmp

You may also like…